HLR Fuse Holder for GMF and GRF Fuses

HLR Fuse Holder for GMF and GRF Fuses

• HLR carrier comes with 6 inches of #18 red insulated solid copper wire attached to the line side.
• Customer inserts a #18 insulated solid copper wire into load side receptacle.
• Order part number HLR-2A to obtain 6 inches of #18 black insulated solid copper wire pre-installed in a load side receptacle.
• Order part number HLR-2L to obtain 6 inches of #18 black insulated
• solid copper wire packaged loose (un-installed).
• An alternative to the HLR fuse holder is the “A” fuse holder. The “A” fuse holder comes WITHOUT leads. The customer inserts #18 insulated solid copper wire into the lineside and the loadside terminals. The “A” fuse holder has the same body dimensions, utilizes the same mounting hole, and takes the same mounting clips as the HLR, HLR-2A and HLR-2L
• Fuse and knob are an integral one-piece unit. There are no replacement knobs (caps).
• Units can be panel mounted with a separate steel clip. For the knockout hole (see above), choose #BK/A-104. For the key- hole punch type hole, choose #6374 for panels .043” to .062” thick, or #4909 for panels .030” to .042” thick.
• Do not put tension on line (rear) terminal of fuseholder.